L298NX2 have the same methods of L298N identified by A or B suffix to drive each motor. Returns a boolean indicating if motor is running or not.

Used to re-enable motor movements after the use of runFor, forwardFor or backwardFor methods. Like previous with the ability to execute a callback function. Unsigned long delay, L298N::Direction direction, CallBackFunction callback To specify the direction use one of L298N::FORWARD, L298N::BACKWARD or L298N::STOP. Like forwardFor or backwardFor but more flexible. Unsigned long delay, L298N::Direction direction Run motor in backward direction for a time specified by delay, after moving execute a callback function. Run motor in backward direction for a time specified by delay. Run motor in backward direction (depends on wiring). Run motor in forward direction for a time specified by delay, after moving execute a callback function. Unsigned long delay, CallBackFunction callback Run motor in forward direction for a time specified by delay. Run motor in forward direction (depends on wiring). Set the PWM value used to determine the motor speed. See FAQ:Where can I find “specific part” for information about looking for existing part files, and information needed to create new parts.// Without Enable pin and jumper in place

Either as is, or as a base for something else. I would not try to use that downloaded part with out some serious cleanup first. To figure out where things are supposed to be, and what should be connected together. To do this properly, a datasheet for the part is really needed. What I see does not have labels except on breadboard, and the part validation tool I use has many complaints. Jumper wires (or cable) would run from the board to a header on the pcb instead. Really, this board does not normally need a pcb view. Spacing and position of the pins on the pcb view also look off. I do not see any of that in the part definition though. Like multiple gnd, or +5V connecting to other +5. Wires are not connecting where they are dragged to except in breadboard view.įewer pins in schematic “CAN” be normal, in cases where multiple physical pins are connected together inside the part. My initial testing of a fresh download of that part says it is broken.

Download library l298n fritzing